CRAMLINGTON, NORTH EAST ENGLAND0191 250 9523PRECISION CUTTING & PROFILING

02 / WATERJET CUTTING

Waterjet cutting
in the North East.

Waterjet cutting up to 200 mm thick in any material, with a 4000 × 2000 mm working bed.

CHOOSE THE PROCESS FOR THE PART

When heat matters,
start here.

Waterjet uses a high-pressure jet, with abrasive for metal cutting, to separate the material. The process avoids a thermal heat-affected zone at the cut.

It can be a useful route for specialist alloys, heat-sensitive components and work that needs a different approach from laser cutting. Edge finish, taper and dimensional requirements still need to be reviewed for each job.

Enquire about waterjet cutting

WATERJET CAPACITY

4 m × 2 m.
Up to 200 mm.

Working bed
4000 × 2000 mm
Maximum thickness
200 mm
Material range
Any material
Cutting process
Cold cutting

Send the material specification and drawing so we can review the geometry, tolerances and edge-finish requirements.

Waterjet cutting stainless steel

We cut the circular opening and outer profile of the part shown from 60 mm thick grade 316 stainless steel plate. Our Flow IFB waterjet uses an abrasive jet to cut the profile without creating a heat-affected zone at the edge.

We stock 304, 316 and 430 stainless steel. If you need a thick blank for machining, mark the faces that will be machined and specify the allowance. For sheet profiles, identify the smallest openings and any edge that will remain visible.

Our bed takes material up to 4,000 × 2,000 mm, with cutting capacity up to 200 mm thick. Send the grade, thickness, quantity and drawing so we can check the features and edge finish for your part.

Request a waterjet quote ↗
Waterjet-cut 60 mm grade 316 stainless steel plate with a large circular opening and a curved outer edge
60 mm grade 316 stainless steel profile, waterjet-cut by Tyneside Lasers.

LASER OR WATERJET?

Let the requirements decide.

You don’t need to select a process before contacting us. These are the questions we’ll work through with you.

01

Material behaviour

Does heat affect the material or the next operation? Does the specification call for a particular cutting process?

02

Part geometry

What are the smallest features, critical dimensions and section thickness? What edge condition is required?

03

Production needs

What quantity is needed, when is it required, and what happens to the part after cutting?

LET’S MAKE IT

Send the specification.
We’ll review the cutting route.

Send the material, quantity and required date. We’ll review the process and the next steps with you.

Request a quote